Home > Fuel Gauge > Fuel Gauge Not Working After Fuel Pump Replacement

Fuel Gauge Not Working After Fuel Pump Replacement

Contents

the wires look ok i jumped them from the plug to the pcm Expert: Dave Nova replied5 years ago. I would hit the local pull a part and get a new sender, you want one from an 87-90 with the same engine as you have. Has no lights or codes. Password Register Forgot Password? weblink

How to fix it - Duration: 6:08. As far as replacing just the float - if your float has sunk, the quality of the rest of the pump assembly is seriously in question, so I would change out I read the posts and figured it had to be the left side fuel level sensor so for $125, I replaced it.....and it didn't work. Working...

Why Does My Fuel Gauge Stays On Full

A mod that 90% of us do is SFC's and they are welded onto the body of our cars. The crap Airtex I have had to have that done. Getting this diagnosed is fairly easy.

Hope this helps someone with same issue.By the way, my truck is a 2005 Avy- 1500 LS (no console) with 49,800 miles, bought it new. I'm gonna go in and attempt a fix next week, and I'll probably cut a hole to avoid the day-long drama experienced last go-round. __________________ 95Z28/M6 - Bolt-ons only best: [email protected] Password Register Forgot Password? Gas Gauge Reads Empty But Tank Is Full My E39 the pump has a spring on the sending unit and the pump has to be seated in the tank properly.

Reply Hide Replies ∧andrew4 months 23 days ago1979 chevy c 20 3/4 ton pickup .. Gas Gauge Reads Full All The Time You may want to detach the fuel pump wiring harness connector from the fuel pump and examine the connector pins/cavities closely for corrosion and bent pins. Tested resistance at the connector leading from the tank at the purple/black wires and I get 0 ohms reading from the two wires. But when i put gas it goes up!

I would also inspect the harness to the tank, make sure the wires have not gotten pinched or cut while installing the tank. Gas Gauge Troubleshooting Common, repetitive, and general discussions will get dumped here from other tech forums. Reply Hide Replies ∧Bruce3 years 4 months agoReplaced fuel sending assembly on 04 Bonneville and gas gauge reads full until tank is 3/4 empty then gas gauge starts to move. No, we do not hand out car sponsorships.

Gas Gauge Reads Full All The Time

So now it's my turn. Amazon has it too. Why Does My Fuel Gauge Stays On Full Now it's showing empty all the time. Dodge Ram 1500 Fuel Gauge Problems yes the jumper is in the harness that plugs into the module from the small black to the small purple wires Expert: Dave Nova replied5 years ago.

You tow the truck home to work more comfortably. have a peek at these guys Fill up over the weekend did not drive tell monday 3 trips to same place then back home it was hott out the day i filled up and was hot out Then I start the car and the gauge only goes 3/4 of the sT up but I know it's full because the handel clicked to max. I've searched other similar threads, but I haven't come across anyone else who can correct the problem just by resetting the computer. Fuel Gauge Stuck On Empty

So my problem may be something to do with the hole where you put fuel in.... User Name Remember Me? Taking the info from my link: 6.0 109330+ ( 109330 = 10.9L for the Left Side of the tank, 33.0L for the right side of the tank) Fuel level averaged; Left check over here I know when the fuel pumps soft fail and do not fully pump the left side of the tank down fully and the car runs out of fuel, the gauge will

Yes but i do not have that info with me.my ex says basically its the gas cap but that has been replaced. Fuel Gauge Reading Incorrectly Alex Barnes LT1 Based Engine Tech 16 01-24-2015 11:21 PM 2002 B4C fuel pump replacement issues? Sign in to add this to Watch Later Add to Loading playlists...

Log In Log In Username Remember Me?

I will wait 20 minuets or so and move the truck by hand 6 feet or(I guess slosh the gas) and it will start. If it does, then take the time to run the wires permanently. Your not resetting your oil service/inspection interval, right? 2005 Chevy Silverado Fuel Gauge Problems No, create an account now.

I was not aware the tank was divided (that it simply had 2 sensors). mine looks like this, the green lined wire is disconnected on the red circled end thanks #17 luv2rallye DSM Wiseman DSM Profiles: 1 Joined: Jun 7, 2003 Posts: 7,185 Likes I would wonder if somehow the float on the new pump is getting hung or was bent? this content Reply Hide Replies ∧Anonymous9 months 5 days agoI am told from research it may be a faulty slosh sensor on 1992 plymouth voyager Reply Hide Replies ∧Rebecca Dailey9 months 7 days

I buy 2 bottles of said treatment. Talyn View Public Profile Find all posts by Talyn #10 May 18th, 2012, 20:34 88_cherokee NAXJA Forum User Join Date: Mar 2012 Location: Puerto Rico Posts: 74 Re: Expert: Dave Nova replied5 years ago. Fst_Byrd Fueling & Injection 7 07-23-2014 11:56 AM Fuel level sensor wiring?

Again, the code number is the key to deciding what part has failed. Newer Than: Search this thread only Search this forum only Display results as threads More... Register FAQ Community Calendar Today's Posts Search Vendor Directory Search Community Links Social Groups Pictures & Albums Members List Search Forums Show Threads Show Posts Tag Search Advanced Search Go