Home > Hampton Bay > Hampton Bay Ceiling Fans Lights Not Working

Hampton Bay Ceiling Fans Lights Not Working

Contents

ConsumerAffairs.com makes no representation as to the accuracy of the information herein provided and assumes no liability for any damages or loss arising from the use thereof. Worked for two weeks then relay shorted and over heated. Here are a few ways to tell if there's a bad capacitor: 1) If the motor hums and the blades move freely but wont spin. 2) If the fan won't start The chain works but the lights won't go on. 09-21-2010, 03:50 PM #5 SABL AdministratorTSF Manager Join Date: Jul 2008 Location: Galena, Ohio Posts: 20,777 OS: WinXP navigate to this website

If the is not one then you need to get on that does other wise a plug is not part of the drain. For about 30 seconds. says: July 12, 2014 at 7:04 PM Love your videos. The Science of Light & Electricity for Kids View Testimonials of our Great Service and Secure Shopping experience. http://community.homedepot.com/howto/DiscussionDetail/hampton-bay-ceiling-fan-light-wont-work-9065000000006IE

Hampton Bay Company Website

February 17, 2016 at 8:47 am Tommy Hoang My lights and fan wont work ! Not sure what to look for. Next, be sure the pull chain is being pulled all of the way out to ensure the switch is actually turning on or off.

I had the CFLs for a while (> 6 mos.) but could hear the "buzz" of the bulb not getting enough juice.

Only issue with the unit, in my opinion, is that Moss The fan part is working fine. It makes an awful noise and I have to turn it off immediately. Hampton Bay Lighting Replacement Parts You want therod to go through the hole on the plug.

If your fan is humming or making noises: It may need to be blade balanced. Hampton Bay Ceiling Fans Manual Sometimes, it may even be more cost effective, and faster, to simply replace the light kit. While damp-rated and wet-rated ceiling fans can be installed indoors, dry-rated fans should not be installed outdoors as these fans are not equipped to withstand moisture or direct contact with water. This can be complicated.

Any idea what the heck could cause this BACKWARD type of operation? Non Contact Voltage Tester Really good thing because I didn't want to change out the light kit - I really liked the one that came with the fan. 01-29-2012, 01:26 PM Lauriedeee Location: The tester does not light if you turned off the right breaker. 4Check the connectors holding the wires from the ceiling fan to the wires from the electrical box. Could you clarify that kind of bulb it is?

Hampton Bay Ceiling Fans Manual

You can buy a ceiling fan pull chain in the lighting section of any hardware store. useful source Then the light flickered twice in about 20 seconds and went out. Hampton Bay Company Website My ceiling fan lights don't work.Its not the bulbs, nor the pull chain for the lights.Any ideas?The fan blades work Page 1 of 2 1 2 > Thread Tools Search Hampton Bay Universal Remote Try flipping it back and forth a few times to re-establish it's connection.

I'm not doubting your 103 measurement, but I am wondering how you measured it. 09-14-09,01:00 PM #3 K8MHZ View Profile View Forum Posts Private Message Senior Member Join Date Mar 2008 useful reference so Thank you! We put those up and they worked for about 2 days. One is worse than the other and is about useless. Hampton Bay Light Kit

Since you’ve moved the ceiling fan from one bedroom to another, verify that all the screws on the canopy, downrod, motor housing and fan blades are secure. Published on Jul 10, 2014http://www.homerepairtutor.com/ceilin...(Save $90 in 10 minutes!!)Do you need to make a ceiling fan light repair? You can buy it at Home Depot. 01-29-2012, 01:09 PM Moonlady Status: "Back in the land of Elvis" (set 2 days ago) Location: Jollyville, TX 3,182 posts, read 7,678,089 http://sistemainmo.com/hampton-bay/hampton-bay-ceiling-fans-light-not-working.php This will help the troubleshooting process.

This is a dangerous product and should be taken off Home Depot shelves immediately. Hampton Bay Ceiling Fans Parts what's wrong and what to do ? 05-02-2014, 09:36 AM Lauriedeee Location: NYC 1,723 posts, read 2,405,412 times Reputation: 2800 Quote: Originally Posted by ej c the light on Without blades attached, the fan will spin with a little "nudge" to get it going.

Don't throw it out..fix it - cheap and easy.Helpful?YesNoMichele D of Holtsville, NY on Aug. 10, 2014Satisfaction RatingI purchased a 3-light chandelier for my kitchen in my new condo.

If it is the the one you pull up on the small rod that sits on the back of the faucet then you have to go under the sink. If the fan has a pull chain in the dead center bottom, that's also the light chain. They will sell you low grade made in China electronics that will break in 12 months then hold you hostage for replacement parts since they DO NOT SELL THE RECEIVER PARTS Harbor Breeze Light Kit I have installed many light fixtures over the years and have never had one with a design that causes cuts to the hands.

So please comment below with as much detail as you can. Then i off-on the switch and it started running 2min fast and 2min slow. To tell if any of the blades are warped, you can use a blade balancing kit. http://sistemainmo.com/hampton-bay/hampton-bay-ceiling-fans-remote-control-not-working.php I moved the fan to a different bedroom & now the motor kinda has a hum to it which was not there before it was moved.

September 19, 2014 at 9:37 am Deborah Mauldin I JUST NOTICE THAT MY FAN WORKS BUT IT'S LIKE LOW SETTING WON'T WORK. Do you think there's enough space between the lifted floor and the subfloor to apply flooring adhesive? Let me know if you have any questions along the way 🙂 Reply Mary O. September 9, 2014 at 11:42 pm Del Mar Fans & Lighting Hello Skip, Thanks for the great question.

At the time we had 2 wall switches and one of them had a dimmer switch on it and somehow that caused the problem. If your light kit is spinning, but the fan blades are not, this could indicate a faulty wiring issue. If I see corrosion on copper I'll use emery cloth to clean it off. Since they don't dim, can't identify"high or low" dim level.

Did anyone else experience this? Would hate to spend 200.00 to replace it. You must buy it from them ONLY.Helpful?YesNoCarlos of Victoria, BC on April 5, 2016Satisfaction RatingBought a Hampton Bay fan light combo with remote. The middle section doesn't screw and fits right into the third section.

Depending on cost it may be wise to replace the whole unit..... Brass my **. If your ceiling fan has an oil bath, check the oil level and replenish oil as needed. Exchanged unit and one side worked, the other the bulb just flickered but would not fully light up.

January 18, 2016 at 10:04 am Leonard Geraci I have a huner fan with lites which worked fine for over a year. If not, you may have to start your own thread. 05-02-2014, 12:56 PM TFW46 12,500 posts, read 14,190,464 times Reputation: 15167 Lauriedeee, what turned out to be the problem