Home > Ice Maker > Ge Integrated Ice System Not Working

Ge Integrated Ice System Not Working

Contents

So if the icemaker completes the cycle and runs water it may just start working again provided the temperature in the freezer is ok (between 0-10 degrees). The fix was to shut off power for 30 seconds. The drip pan is directly behind these wires and warm moist air is being blown directly over these wires every time the defrost fan comes on. First: I "warmed up" the freezer section by changing the setting from 5 to 4.

Reply Jeanette McDonald October 12, 2014 at 9:53 am Watched your video - the light still works in the door - the opening for the ice to come Register Help I'll have to confirm that with the fridge out, but we looked back there before. Appliance parts online, right part, best price and fast shipping. The jumper should be insulated 14 gauge solid wire that has the insulation stripped back about 3/4 of an inch on both ends, and bent into a “U” shape.

Ge Ice Maker Not Making Ice

Perhaps try a new filter to see if that fixes the issue. Also check to see if the tube going to the icemaker is clogged with ice. My best and quickest solution was to pull the copper wire out of a plastic wire thus creating a flexible hose/tube about 25cm long which would fit up the opening of

Worst case is your fridge gets cleaned out, best case you fixed it and it doesn't cost a dime. Or check out the related posts where we list some possibilities for your issue. Pull out the frige. Ge Ice Maker Parts After it has sat warm for a while it will start to work again.

Se podrá valorar cuando se haya alquilado el vídeo. Ge Ice Maker Reset Strip and twist the lead wires back and done. Reply George December 28, 2014 at 8:55 pm Did you ever get an answer? Get More Info Traced problem to the filter assembly.

Typically it will take 24-48 hours for an icemaker bin to fill and longer if the refrigerator is just starting up. Ge Under Counter Ice Maker Siguiente How to Troubleshoot Icemaker Issues - Duración: 2:12. My husband did the hair dryer last week because nothing was dispensing, and now most of the time it wont stop. Good luck and let us know what you find.

Ge Ice Maker Reset

I too have a GE side-by side, and my water and ice maker work fine….most of the time. Do you have any Idea what my problem could be? Ge Ice Maker Not Making Ice If you use one of those clamp on saddle valves they are notorious for restricting flow. Ge Refrigerator Ice Maker Not Getting Water The interior light is NOT giving me a fault mode indication, which leads me to believe that this is a water supply problem, rather than an electronic one.

I don't really know where the valve is. That could get things going again. Some time ago my husband fixed our side by side GE fridge with no problems thanks to a video of yours. What you described makes sense: when you depress the water dispenser, it tells the valve at the back of the fridge to open and release water which then runs the water Ge Refrigerator Ice Maker On Off Switch

Searching with your model will also give you access to even more information about this symptom and instructions on how to install your repair part. You will have to investigate this by removing the button panel and getting access to the switch. Vegetable drawers etc replaced as always. My icemaker will not stop making ice, overflows the bucket.

You might want to put a glob of dielectric paste where the wire enters each crimp connector to keep the water vapor out. Ice Maker Not Making Ice Frigidaire Angela Gottschalk 904.655 visualizaciones 3:08 Troubleshooting Why the Ice Maker Is Not Working | PartSelect.com - Duración: 4:14. Most heat release ice makers will have a removable cover at the front.

Inspect the fill tube and the fill cup area at the back of the ice maker to make sure that they are not frozen.

Be careful, or you'll break the clips. Reply Wolf June 19, 2013 at 11:11 am I wonder, if replacing the bulb did fix your issues. NEW BULB DID NOT WORK Reply WIL DRAKE January 10, 2014 at 8:56 pm WHAT FIX THE PROBLEM? Ge Profile Refrigerator Ice Maker Problems French Door The heat shrink tubing will seal the connections from the water vapor (unlike the crimp connectors).

EXACT same problem. I also disconnected the ice maker water line supplly from the filler tube and when I did a manual pressure check on the 1/4" line, it seemed as though it was My dispenser lights are not working. All rights reserved. © Applianceblog.com 2004 - 2016

Also note that sometimes the icemaker will go into a lockdown mode for unknown reasons. Try this. Try shutting off the water at the saddle valve (if you have one) and then back on again. ET Saturday–Sunday: 8 a.m. – 6 p.m.

Reply The Handyguys June 4, 2013 at 3:31 pm The Handyguys are not appliance repairmen and we have not researched the flapper issue. If the icemaker completes the cycle and water runs in either the temperature inside the freezer is too warm (should be between 0-12 degrees) or the thermostat inside the icemaker is Thanks for the feedback! Its a cheap thing to do (and easy if you can solder) and will likely increase flow.

It keeps on blinking on the same " water indicator" What can I do? Reply Ellen July 10, 2013 at 11:28 am We actually found the problem, and it is terribly silly actually.