That black square thing that surrounds it how do I get it off with out destroying it. Use your smart phone to take a picture of the model number tag. We are vigilant and release the ice, and manually close the door, however, frost forms in the doorway overnight and this results in crushed ice when we want to receive ice I have seen some designs that just used a large coil of supply line in the fridge behind the bottom drawer. have a peek at these guys
Problem solved - flapper closes and no ice has formed on the chute or flapper for over a year. I put the light back in and sure enough the problem came back. Reply The Handyguys July 10, 2013 at 1:32 pm Reply shari July 10, 2013 at 2:22 pm As my refrigerator was under an extended warranty, I finally called the guys out! Reply Charles Merlo April 28, 2013 at 9:06 am Absolutely positive1 Reply Bob Thomas May 1, 2013 at 11:06 pm It sounds to me as if you had an
I just asked for a replacement (free) and the next one lasted over a year so far. Has there been any similar complaints on this fridge and what can I do to correct it? Schedule Service Online Update a Service Appointment or Check Pricing GE Appliance Service 1-800-GECares (1-800-432-2737) Monday–Friday: 7 a.m. – 10 p.m.
Thanks for sharing. Was on another forum and someone said they removed the light on the dispenser and the problem was fixed. If there’s ice stuck in the device, or if it’s just not filling properly, let it sit out for a few hours until it warms up. Ge Profile Refrigerator Ice Maker Problems French Door These seem to help stabilize the temperature, and keep the door area from getting too cold.
Easy to remove. Ge Refrigerator Ice Maker Not Getting Water Reply Charles Merlo May 28, 2013 at 11:12 am Thanks for the input Bob. Now the water and ice will not dispense. http://www.geappliances.com/ge/service-and-support/refrigerators-freezers.htm Could the circuit board being slowly dying?
Top 5 Reasons Refrigerator Is Noisy? Ice Maker Not Making Ice Frigidaire Put in the filter bypass but still no go. I have turned off the icemaker and really don't need the water line. If this is the case, the water/ice dispenser will still work.
Low household water pressure or a restriction at the manual shut off valve will also cause the water inlet valve to not shut off completely and create this same condition. Look for some screws around the panels edge. Ge Refrigerator Ice Maker On Off Switch I am going to try to replace the board on the frig to see if that will get my water working again. Ge Ice Maker Parts Easy quick Ice Maker fix if your ice tray suddenly stops filling.
hammydude12345 559,954 views 4:06 Loading more suggestions... More about the author Someone at the following site says that it's a faulty filter housing assembly. Water tank leak. Fixed 10/2011. 3. ET Sunday: Closed GE or RCA Consumer Electronics (TVs, VCRs, radios, phones, more) International Product Information Canada: 800-361-1100 Monday–Friday: 8:30 a.m.–9 p.m. Ge Under Counter Ice Maker
My thinking is the seal between the freezer and dispenser failed or the seal allowing water flow failed, leading to the leak. Why is that? Reply alfonds June 25, 2014 at 3:44 pm My GE Refrigerator M# TFX25PRT, dispenses only warm water-All the time!!!Never mind that the referig. http://sistemainmo.com/ice-maker/gsi-23-ice-maker-not-working.php Is this my fault for forgetting to add the water?
If the dispenser actuator is broken, it may not activate the switches properly or at all. Ge Bottom Freezer Refrigerator Ice Maker Problems Top 5 Reasons Refrigerator Is Freezing Food? I have used this method several times and just keep the water bottle handy for future use.
in the meantime…I got a new flapper, new solenoid, new electrical panel, new springs and new anything else it could be! Reply Frank December 20, 2012 at 10:25 pm Hello - my problem sounds similar to maxsmama. Don't be so sure. Ge Ice Maker Kit Cause 3 Ice Maker Assembly One component of the ice maker assembly might be defective.
Use your smart phone to take a picture of the model number tag. Reply Jonathan July 14, 2016 at 6:30 pm One of the GE water tube heaters I installed also failed within a few weeks. Do you have any Idea what my problem could be? news Strip and twist the lead wires back and done.
I have used temporary means to collect the water We never use the dispensers anymore. Replaced filter with bypass and the problem was still there. I guess that they feel like what's a few thousand customers, their future business, and tarnished reputation? After a little bit of investigating this is what we determined.
The unit can be manually operated by inserting an insulated jumper wire into test points “T” and “H” to initiate a “test harvest”. doublewide6 350,644 views 3:00 Refrigerator Water Inlet Valve (part #W10408179)-How To Replace - Duration: 9:55. Here's a video that explains the entire process and gives you the model number: http://www.youtube.com/watch?v=BdNX3LteJTw Reply Marsha May 1, 2013 at 5:03 pm I leave my light bulb in the dispenser