Home > Ice Maker > Ge Refrigerators Ice Dispenser Not Working

Ge Refrigerators Ice Dispenser Not Working

Contents

Any other ideas short of replacing the door are appreciated. Reply Richard October 10, 2014 at 11:30 am GE ice maker making an occasional cube but not a full tray so in 24 hours we have only about 6 cubes. Now I had turned the freezer control one level warmer so perhaps that worked or helped also. What did you eventually decide for your solution ? this content

I had tried blow drying inside and in the spout before. I now know we have a defective ice maker unit. Thanks for the encouragement! repeat until fixed.

Ge Ice Maker Reset

I have actually seen this same issue. I also turned on the small light by the water dispensing unit. If you look at the photo of the bottom of the tray, you can see the "U" shaped heating element. Remove the washers and the blades and place them on the table in the order in which you removed them.

Have had a chronic problem of a frozen water line to the dispenser. The GE reply of "out of warranty" or "issue does not apply to your particular model", did not work this time; http://www.nbcphiladelphia.com/news/busi... We now have any empty bucket sitting on top of the fridge to catch the overflow as we never know if either ice or water will stop when we release the Ge Refrigerator Ice Maker On Off Switch Ice Maker Is Frozen Up This ice maker repair is even easier.

WattsIce maker tap valve and copper tubing used to connect to a water pipe come as a kit. 5Check the tap valve. We have a similar model GE. Sometimes it sticks, sometimes it doesn't.

ApplianceVideo.com 50,193 views 9:59 Refrigerator Ice Dispenser Motor (part #WP2188242)-How To Replace - Duration: 7:31.

Use your smart phone to take a picture of the model number tag. Ge Bottom Freezer Refrigerator Ice Maker Problems Was this answer helpful? As I previously stated - GE repair man had installed a water heater in the interior of the freezer door as the problem had occurred while under warranty. So once the cover is removed the motor comes out with it.

Ge Profile Refrigerator Ice Maker Problems French Door

Reply Barney Clark June 20, 2013 at 11:21 pm My G E refrigerator in door water dispenser that you push to get water is broken and needs to be replaced. I tried several methods and a lot of time to thaw it. Ge Ice Maker Reset Same for me...about 8-10 minutes with a hair dryer and it was flowing! 01/24/2015 by house916 Thank you.. Ge Adora Refrigerator Ice Maker Troubleshooting If I try to fill with ice first, it doesn't work.

Joe Wier 26,671 views 7:58 How Does The Ice Maker On A Refrigerator Work? — Appliance Repair & Troubleshooting Tips - Duration: 3:32. news Sandi Abdow Our Samsung French door ice maker is not working & is making noise. Amazing! I don't really know where the valve is. Ge Ice Maker Parts

The unit can be manually operated by inserting an insulated jumper wire into test points “T” and “H” to initiate a “test harvest”. took it out now the fan and copm. Was this answer helpful? http://sistemainmo.com/ice-maker/frigidaire-refrigerators-ice-maker-not-working.php Pressing the water button does not change from to ice dispenser either.

Meanwhile the water dispenser works fine. Ge Refrigerator Ice Maker Not Getting Water Had read about inserting warm water but also saw someone had used weed eater line. But the ice-dispenser unit in the door fills with water.

To do this, you can train a hair dryer on the ice maker to melt any ice blocking the mechanism.

I consider it an unnecessary, trouble causing feature. I was about to order a circuit board when I came across this. Thanks everyone… Reply Sandy Train February 22, 2014 at 4:00 pm My GE side by side, when we get water out of the door it rattles and eventually stops dispensing water. Ge Under Counter Ice Maker I wish I can post a picture, let me know if that does not work. 08/04/2014 by shoolcool Add a comment 0/1024 Cancel Post comment Are you sure you want to

There is also a switch close to the dispenser that sends the signal to the water pump. Cancel s k Rep: 1 Posted: 08/30/2014 Options Permalink History What was the cost for control board and new tubing? All rights reserved. check my blog The part that was faulty is called the water filter head (it is what the water filter attaches to).

What should happen is the solenoid should lift and the auger motor should turn. Could the mother board be failing? Was this answer helpful? Yes No Voted Undo Score 0 Cancel Comments: The water filter head (what the filter attaches to) is likely bad.

Rich Was this answer helpful? Yes No Voted Undo Score 0 Cancel Add a comment 0/1024 Cancel Post comment Are you sure you want to delete this zzzzzz? The water line attaches to a solenoid at the back or bottom of the refrigerator and then travels to the ice maker. You should be able to see which one is broken.

I had to use pliers to pull the weed wacker line out but it cleared the line out. That connection is often made with what is called a saddle valve. You could also push the lever inside the freezer with your hand. Thank you for your postings.

I purchased and installed this updated part and now the water is again dispensing and ice is being made normally. To determine this, first remove the ice dispenser bucket, select cubed ice, open the freezer door, press the door switch and press the button to get ice. Thank you for your note ;) 06/19/2015 by helafandi Thanks, I tried the hair dryer and it worked fine after a few minutes, and did so the whole day. The original solution was to wait overnight and hope my water and ice dispenser problems went away.  It did begin working again for a few days at a time.  A few weeks later it only

Thanks for all of the input :) May 24 by phyln96 It appears a Burlinton NJ resident was experiencing same issue of GE fridge dispenser not working, and after having tech Reply The Handyguys May 24, 2013 at 10:55 am Yikes - You might try and see if you can buy a new door online or just replace the fridge.