Home > Refrigerator Water > Ge Refrigerator Water Line Not Working

Ge Refrigerator Water Line Not Working


Is the ice maker or water dispenser turned on? I've checked the door switch inside, making sure that it popped in and out easily. Glad you got it fixed! More Repair Parts Start Your Repair Here We have refrigerator parts for thousands of models Search Need Help Finding Your Model Number? http://sistemainmo.com/refrigerator-water/ge-profile-refrigerator-water-line-not-working.php

The old one was 6 months old so it was time to replace it. Was this answer helpful? If your fridge is not dispensing water, don’t give up – we can help. Refrigerator worked perfectly dispensing water and ice.

Ge Refrigerator Water And Ice Dispenser Not Working

Yes No Voted Undo Score 1 Cancel Add a comment 0/1024 Cancel Post comment Are you sure you want to delete this zzzzzz? Next, place the water line into a bucket and momentarily turn the water valve back on to test the flow. I purchased and installed this updated part and now the water is again dispensing and ice is being made normally. The inlet valve and the supply valves are all one piece.

I just paid $69.50 for a service visit. PartSelect 623,079 views 3:11 Refrigerator Water Inlet Valve (part #W10408179)-How To Replace - Duration: 9:55. Not sure what the cause is.Reply 120 DIY Project Help Tips October 9, 2015 at 3:20 pmTeresa, You may have a blockage in the water line that causes pressure and therefore Frigidaire Refrigerator Water Dispenser Not Working Any suggestions where to go next?

So connect the bottom of the filter to the water line but flush out/let the water flow through the filter before connecting the top of the filter to the water line. Ge Refrigerator Water Dispenser Not Working But Ice Maker Is Cancel chickenlittle2334 Rep: 1 Posted: 05/08/2015 Options Permalink History i only got my frigde today and i cant even to get the water and ice dispenser to work. Please be detailed in your description and we can try and assist further. -RRReply 127 Kim September 27, 2015 at 2:13 amWe have a Whirlpool side-by-side. This is due to a delay in the overall system.Dribble can be minimized by the following actions:Purge the tank, by holding down the dispenser for 2 to 3 minutes, to remove

MORE ABOUT THIS REPAIR - Customers rate this repair as Easy - 15 - 30 minutes We have 424 installation instructions We have 14 step-by-step videos The dispenser micro switch is Whirlpool Refrigerator Water Dispenser Not Working Please change the filter. How to remove and replace a water filter MORE ABOUT THIS REPAIR - Customers rate this repair as Really Easy - less than 15 minutes We have 391 installation instructions We ThanksReply 69 Mike January 31, 2016 at 11:32 pmWell I thought I had it solved.

Ge Refrigerator Water Dispenser Not Working But Ice Maker Is

With the unit unplugged I removed the rear panel on the bottom (six bolts) and found the coils completely obstructed with dust. Here is illustration showing where to hold blow dryer; http://www.applianceblog.com/mainforums/... Ge Refrigerator Water And Ice Dispenser Not Working I When I jump tested the valve it put water in the ice maker, but when everything is hooked up correctly no water is going into the ice maker. Ge Refrigerator Water Line Frozen Reply Cecilia sparks January 3, 2015 at 2:38 pm # whoops!

Check to be sure there is nothing that got jammed in the filter housing when you replaced the filter. http://sistemainmo.com/refrigerator-water/ge-arctica-refrigerator-water-not-working.php Cancel Rich Benson Rep: 61 1 1 Posted: 02/21/2015 Options Permalink History Guys, the tube continues to freeze, you will probably find the same @Monique. To disconnect the tube, push the white retainer fitting in while pulling on the tube. If the power went out sometimes a fridge will display an error code telling you so… Can you reset it using the control panel? Ge Refrigerator Water Dispenser Not Working After Replacing Filter

It looked like a time lapse of a rose wilting. Yes No Voted Undo Score 0 Cancel Comments: The water filter head (what the filter attaches to) is likely bad. Top 6 Reasons Refrigerator Isn’t Cooling? http://sistemainmo.com/refrigerator-water/ge-refrigerator-water-not-working.php He told me there was a heater part that would heat it up to keep from freezing.

There is a blue pressure fitting disconnect the line going up into the door. 5 Gallon Water Dispenser Not Working GE Refrigerator Slow Water Dispenser? Reply Anonymous March 26, 2015 at 1:55 pm # An 8 inch piece of whipper snipper cable inserted up the water line/cord at the dispenser works fine.

I'm so glad I did some investigating of my own before making a service call.

Yes No Voted Undo Score 0 Cancel Add a comment 0/1024 Cancel Post comment Are you sure you want to delete this zzzzzz? Then close the freezer door and press the lever to get water. Naturally, the water doesn't dispense. Kenmore Elite Refrigerator Water Dispenser Not Working Thanks k you so much for sharing.

This should hold the cold for a while. 4) leave the door open for about 2 hours…problem usually solved. 5 this is a chronic problem…hang onto the panels you will likely I shall see if that keeps the line thawed. Cancel Robert Scoft Rep: 25 1 Posted: 11/28/2014 Options Permalink History A flaw in the design of these units causes door insulation or seal to deteriorate over time and as a http://sistemainmo.com/refrigerator-water/ge-refrigerator-water-dispenser-not-working.php This switch activates the refrigerator light when the door is open.

Is the valve fully open? Thanks for all the help. Reply Peter January 20, 2015 at 1:12 am # Penny, Thank You! The fridge is fine.

We've tried different brands, but same problem. GE Service tech admitted that there were problems with the original ice maker design! There may be gunk in the line somewhere. If there is a slight dribble of a few drops of water after using the dispenser, this is normal and due to a delay in the system.If the water dripping from

The green light over the water button will go out when the dispenser lever is pressed and no water comes out. The water heater in the line seemed to fix the issue and we never saw it again. you push the white ring in and the hose will pull out. I'm not actually sure the solenoid is good as I only testing it (wires disconnected) at around 25 ohms (not open or short) which another post said was O.K.

The ice maker is filling the trays and dumping into the holding bin. Sign in 1,906 67 Don't like this video? Check its electrical connector.